Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Cedar Park, TX
Chimney repair in Cedar Park usually means one of two things: freeze damage to the crown or flashing, or a prefabricated fireplace from the 1990s that was barely used and now has a dry-rotted damper and cracked firebox. Ashton Chimney has served Cedar Park since 2014, and we see both patterns constantly. The housing stock here runs from 1970s masonry chimneys near the original town center to 2000s tract homes with factory-built metal units, and each one fails in its own way. If you need a straight answer about what’s wrong and what it costs to fix, call us at (855) 507-9184.
Why Cedar Park Homes Are Different
Cedar Park’s humid subtropical climate means long, hot summers where fireplaces sit completely idle. That idle time is harder on a chimney than steady use. Moisture settles into the flue, dampers rust in place, and pests build nests in caps and crowns. Then a hard freeze hits, like the ice events that sweep through Williamson County every few winters, and the freeze-thaw cycle cracks masonry crowns and flue tiles that were already weakened. After those freezes, our phone rings with homeowners in Buttercup Creek and Cypress Creek who lit their first fire in two years and discovered the damper wouldn’t open or water was staining the ceiling around the chimney.
The housing stock adds another layer. Most Cedar Park homes were built between the 1990s and 2010s as suburban tract developments, and a large share of them have prefabricated metal fireplaces or direct-vent gas inserts. These are not built like masonry fireplaces and they do not repair like them either. The older pockets closer to the original town center, including homes from the 1970s and 80s, have true masonry chimneys with clay tile liners and brick exteriors, and those have their own aging pattern. We adjust our inspection approach based on what we’re standing on, because a prefab unit and a masonry chimney need completely different repair paths.
Styles & brands we work with
Our Main Cedar Park Services
Cedar Park homeowners call us most often for two reasons: a chimney that needs sweeping and inspection before burning season, and a dryer vent that has never been cleaned since the house was built. Both are fire-safety services, and both are handled by the same crew.
Chimney Sweep in Cedar Park
A sweep in Cedar Park is rarely about heavy creosote. The mild winters mean most fireplaces see light, occasional use, so what we find instead is disuse damage: stuck dampers, rusted firebox panels, wasp nests in the cap, and cracked refractory panels in prefab units. Our sweep includes a full visual inspection of the firebox, damper, flue, and exterior chimney, with a written report on anything that needs attention. The full details on what a sweep covers, what it costs, and how to prepare are on our Chimney Sweep in Cedar Park page.
Dryer Vent Cleaning in Cedar Park
Your dryer vent is a venting system just like a chimney, and in Cedar Park’s two-story tract homes it often runs 15 feet or more through walls and floors before it exits the house. That length means more surface area for lint to accumulate, and in a climate where families run dryers year-round, the buildup happens faster than people expect. We clean the full vent run from the dryer connection to the exterior termination, check the vent cap, and document the before-and-after with a camera. See the full breakdown on our Dryer Vent Cleaning in Cedar Park page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Cedar Park
Chimney repair in Cedar Park splits into two distinct categories, and the split follows the housing stock. In the 1990s and 2000s tract homes, we are usually repairing or replacing components of prefabricated fireplace systems: caps, crowns, dampers, and refractory panels. In the older masonry chimneys near the original town center, the work is more structural: cracked crowns, failed flashing, and deteriorated flue tiles. Freeze damage from Cedar Park’s occasional hard freezes accelerates both categories. For the full scope of what we handle, see our Chimney Repair service page.
Chimney Cap Installation
Signs you need it
You see rust flakes in the firebox, hear birds or animals in the chimney, or the existing cap is missing, dented, or letting water in during storms.
What it costs in Cedar Park
A standard chimney cap installation in Cedar Park typically runs $300 to $500 depending on the flue size, but is often done as part of a larger repair.
How we do it
We measure the flue opening, install a correctly sized stainless or copper cap from manufacturers like Gelco or Copperfield, and secure it with mechanical fasteners rated for exterior exposure.
Chimney Flashing Repair
Signs you need it
You have water staining on the ceiling or wall around the chimney after rain, or visible rust, gaps, or lifted flashing at the roof line.
What it costs in Cedar Park
Chimney flashing repair in Cedar Park typically costs $600 to $2,000 depending on whether it’s a small reseal or a full step-flashing replacement through shingles.
How we do it
We cut back the shingles or siding around the chimney, remove the old flashing, install new step and counter flashing with proper weep drainage, and seal all transitions.
Chimney Crown Repair
Signs you need it
The concrete crown on top of your chimney has visible cracks, spalling, or missing sections, and water is entering the masonry below.
What it costs in Cedar Park
Chimney crown repair in Cedar Park typically costs $900 to $3,000 depending on the crack pattern and whether a full crown replacement is needed.
How we do it
We assess the crown cracks, apply a flexible crown sealant for hairline repairs or pour a new properly overhanging crown for major damage, and ensure the flue and cap are set correctly.
What Chimney Repair Costs in Cedar Park
| Item | Typical range in Cedar Park |
|---|---|
| Chimney cap installation | $300 – $500 |
| Chimney flashing repair | $600 – $2,000 |
| Chimney crown repair | $900 – $3,000 |
Do I need a permit for chimney repair in Cedar Park?
Most component-level repairs like caps, flashing, and crown sealing do not require a permit in Cedar Park, but structural modifications or full rebuilds may. We will tell you if your job triggers a permit and handle the paperwork on our end when it does.
How long does chimney repair take in Cedar Park?
Most cap, flashing, and crown repairs are completed in one visit, typically 3 to 6 hours on site. Larger structural work may require a follow-up, and we will confirm timing before we start.
Brands We Service in Cedar Park
We install and service chimney components from Copperfield, DuraFlex, and HeatShield. These are professional-trade brands, not hardware-store substitutes. Common cap sizes and flashing materials are stocked locally, so most repairs do not wait on shipping. For a full look at what we work with, see our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Cedar Park, TX
| Service | Typical range in Cedar Park |
|---|---|
| Chimney sweep and inspection | $180 – $340 |
| Dryer vent cleaning | $145 – $195 |
| Chimney cap installation | $300 – $500 |
| Chimney cap replacement | $350 – $550 |
| Chimney liner installation | $2,500 – $6,500 |
| Chimney flashing repair | $600 – $2,000 |
| Chimney crown repair | $900 – $3,000 |
| Damper repair | $250 – $600 |
| Firebox repair | $400 – $1,500 |
| Chimney masonry repair | $800 – $4,000 |
What pushes a repair price up in Cedar Park is usually access: steep roof pitches on two-story tract homes, chimney locations at the ridge line, or repairs that require scaffolding around a tall masonry stack. The price we quote before we start is the price you pay, and we walk you through any add-ons with photos before any work happens.
Neighborhoods We Serve in Cedar Park
We work throughout Cedar Park and the surrounding area, and because we are local, we know the difference between a 1970s masonry chimney near the old town center and a 2010s prefab unit in a master-planned development off Ronald Reagan Boulevard. Most of the neighborhoods below are within a 20 to 30 minute drive of our Cedar Park routes.
- Buttercup Creek
- Cypress Creek
- Ranch at Cypress Creek
- Forest Oaks
- Carriage Hills
Service Area – Cities Near Cedar Park
Ashton Chimney serves Cedar Park and nearby communities across Williamson and Travis counties. If you are in Brushy Creek, TX, Anderson Mill, TX, Jollyville, TX, or Leander, TX, our technicians can reach you on the same Cedar Park-area routes. Give us a call and we will confirm the next available appointment window.
Serving Cedar Park, TX — Our Local Coverage Area
We’re based in the Cedar Park area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Cedar Park
Most Cedar Park appointments are scheduled within the same week, and after a hard freeze or ice storm we add extra route days to handle the surge. Call (855) 507-9184 and we will give you the next available date and a two-hour arrival window.
Some Cedar Park HOAs require exterior changes like chimney caps to match a specific finish, usually black or copper. We stock both and can match most community requirements, but check your HOA’s architectural guidelines if you are unsure before ordering a custom cap.
Yes. Direct-vent gas inserts and prefabricated fireplaces make up a large share of Cedar Park’s housing stock, and we inspect, clean, and repair those systems just like masonry chimneys. The venting, cap, and termination points need the same annual attention.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Cedar Park Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Alicia Hampton"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Nisha Patel"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Dustin Whitaker