Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Anderson Mill
Dryer vent cleaning in Anderson Mill typically costs $149 – $289 for a standard single-story ranch home, and most jobs take 60 – 90 minutes. If your dryer takes two or three cycles to dry a load, the problem is almost never the appliance. In Anderson Mill, it’s usually the vent line packed with live oak catkins, cedar pollen, and years of baked-on lint. Call (855) 507-9184 for a free estimate, and we’ll walk you through what we find.
Most Anderson Mill homes were built in the 1970s and 80s, and many still have the original dryer vent configuration that was code at the time. That means foil transition ducts behind the dryer, long horizontal runs, and vent terminations tucked under low-pitch roof soffits where Anderson Mill’s live oaks and cedars drop more debris than any flapper door can shed. We’ve worked these houses for years, and we know exactly what to look for before we even open the dryer.
Why Ashton Chimney Is Anderson Mill’s Preferred Dryer Vent Cleaning Company
Anderson Mill homeowners call us because we treat a dryer vent as a venting system, not a five-minute add-on. Nolan Pruett built Ashton Chimney around that principle: professional-grade materials, straight answers, and no hand-off to a subcontractor. The same tech who cleans your dryer vent can inspect your chimney, repair a cracked flue liner, or run a camera through a wall penetration you’ve never been able to see. One company handles the sweep, the repair, and the sign-off.
We also understand the older housing stock here. Homes off Anderson Mill Road, Lake Creek Parkway, and in the neighborhoods around El Salido Parkway were built before smooth-wall rigid duct became standard. Many still have white plastic or foil transition hose that collapses behind the dryer, or vent hoods with flapper doors that don’t fully close. That’s not a reason to replace the vent. It’s a reason to have someone who knows what they’re looking at clean and inspect it correctly.
Our Dryer Vent Cleaning team covers all of 78729, from the western edge near Ranch Road 620 to the eastern boundary along MoPac. We schedule around your workday when we can, and we call when we’re 20 minutes out.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Anderson Mill
Every job starts the same way: we pull the dryer out, check the transition duct behind it, then clean the full run from appliance to termination. No shortcuts, no surface-only “cleaning” that leaves the fire risk exactly where it was. Here’s what that looks like in Anderson Mill specifically.
Full-Run Rotary Brushing
Rotary brushing is the core of what we do. A spinning nylon or wire brush feeds through the entire vent line, scrubbing the walls clean rather than just blowing loose lint toward the outside. In Anderson Mill, where long hot summers bake lint into a hard glaze on the pipe interior, this step matters. A shop-vac alone won’t cut through that crust. The brush does.
Transition Duct Replacement
Behind most Anderson Mill dryers is a length of foil or semi-rigid hose that’s been there since the house was built or since the last appliance was swapped. These collapse, kink, and trap lint faster than any other section of the system. We replace crushed or torn transitions with smooth galvanized pipe or proper UL-listed semi-rigid duct. It’s a small fix that usually cuts dry times in half.
Exterior Vent Hood and Flapper Cleaning
Anderson Mill’s live oaks drop catkins in spring, and the Ashe junipers fill the air with cedar pollen through the winter. Both end up stuck to the outside vent hood and the flapper door. When the flapper can’t close, hot attic air and moisture get pulled back into the pipe, and lint sticks to everything. We clean the hood, clear the flapper, and make sure it seats properly.
Camera Inspection and Photo Report
If a vent line is unusually long, runs through a crawlspace, or has been cleaned before without resolving slow dry times, we run a small camera down the pipe. You’ll see exactly what we see, before and after. Nothing gets recommended without visual evidence you can look at yourself. That’s our standard on every Anderson Mill job where it’s warranted.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Anderson Mill
We don’t install off-the-shelf hardware-store substitutes. When we replace a transition duct, vent hood, or wall cap, we use products from Copperfield and Gelco, the same lines chimney and venting professionals specify. We name the products we install so you know exactly what’s going into your home. For dryer vent runs that have been crushed or damaged, we’ll source the right replacement components locally and often have them on the truck. In Anderson Mill, that means we usually complete the whole job in a single visit.
Common Dryer Vent Cleaning Problems We See in Anderson Mill Homes
- Vents that terminate under the soffit. Many 1970s-80s ranch homes in Anderson Mill were built with dryer vents exiting through the eave rather than a side wall. Live oak catkins and cedar fluff land directly on the vent hood, clump with moisture, and pack the opening shut. From the ground, everything looks fine. From the roof, it’s a different story, and that’s where we inspect.
- Collapsed foil transitions behind the dryer. The original foil or plastic hose gets shoved against the wall every time someone pushes the dryer back. After 20 or 30 years, it’s kinked flat or torn open. Lint pours into the gap between the wall and the appliance, and the dryer works harder with every cycle. Homeowners think the dryer is dying. It’s not. It’s suffocating.
- Hard, baked-on lint glaze inside the pipe. Central Texas heat doesn’t just bake your driveway. It bakes the inside of your dryer vent too. After months of 100°F-plus attic temperatures, loose lint cures against the pipe wall into a crust that resists air movement. A quick vacuum pass leaves the glaze behind. Rotary brushing is what removes it.
- Pest nests near the termination. Under-eave vents with broken flappers are an open door for small birds and rodents, especially in the fall. We find nests built right up against the exhaust opening, usually mixed with lint and oak leaves. The fix is cleaning the run, replacing the flapper, and sometimes adding a pest guard hood.
See the difference
Before
After
Before
After
Before
AfterPricing for Dryer Vent Cleaning in Anderson Mill, TX
A standard dryer vent cleaning in Anderson Mill runs $149 – $289 for most single-story ranch homes with an accessible vent run under 15 feet. Two-story homes or vents that exit through the roof typically fall between $209 – $349 because of ladder work and longer hose runs. If the transition duct behind the dryer needs replacement, that adds $45 – $95 depending on material and length. If we’re already on site for a chimney sweep, we knock $25 off the dryer vent price.
Every quote is flat and agreed to before we start. No add-ons after the fact. Call (855) 507-9184 and we’ll give you an exact number over the phone based on your home’s age and vent configuration.
We Also Serve Cities Near Anderson Mill
Most of our Anderson Mill customers find us through neighbors in Jollyville and Brushy Creek, where we’ve cleaned and inspected vents for years. We also handle Dryer Vent Cleaning in Anderson Mill‘s surrounding communities, including Cedar Park and Wells Branch. If you’re anywhere in the 78729 area or just outside it, give us a call.
Serving Anderson Mill, TX — Our Local Coverage Area
We’re based in the Anderson Mill area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Anderson Mill
Once a year, and ideally in early fall before the cedar pollen peaks and the heating season begins. Anderson Mill’s live oaks drop heavy catkins in spring, and Ashe junipers spread pollen from December through February. That organic material collects on the outside vent hood and gets pulled inside. Annual cleaning stays ahead of the buildup. If your dryer already takes two cycles to dry towels, call (855) 507-9184 sooner rather than later.
Because the vent line is restricted, not because the dryer is failing. In Anderson Mill specifically, we see three repeat causes: under-eave vent hoods packed with oak catkins and cedar fluff, collapsed foil transition ducts behind the machine, and hard lint glaze baked onto the pipe interior during the long hot summer. We find and fix all three in a single visit.
Yes. The lint screen catches maybe 30 percent of what passes through it. The rest travels into the vent pipe, where heat, moisture, and time turn it into a dense, fuel-rich mat. A clean screen does nothing for the 10 feet of pipe behind the wall. National fire data consistently ranks dryer vent blockage as a leading cause of household dryer fires, and Anderson Mill’s older ranch homes with long under-eave runs are exactly the kind of properties where this builds up fastest.
Sometimes, yes. If your vent terminates through a roof cap, we need roof access to brush the full run properly and clear the cap. If the vent terminates under the soffit or through a side wall, we can usually handle everything from inside and from a ladder. We’ll tell you which one yours is when you call, and we’ll price it accordingly.
Different systems, same fire-safety principle. A dryer vent carries hot, lint-filled air from the appliance to the outside. A chimney carries combustion gases from a fireplace or stove. Both need clear passage and periodic mechanical cleaning. Ashton Chimney does both, which is rare, and it means one call covers your whole household venting picture. We’ll inspect both while we’re there and tell you plainly what needs work and what can wait.
Call Ashton Chimney for Dryer Vent Cleaning in Anderson Mill, TX
If your dryer sounds like it’s working harder than it used to, or your laundry room stays warm while the dryer runs, the vent is telling you something. We’ll inspect it, clean it properly, and show you what we find. Flat pricing, one visit, no pressure. Call (855) 507-9184 for a free estimate, or schedule online and we’ll call you back within one business day.
Written by Nolan Pruett, Owner at Ashton Chimney, serving Anderson Mill and surrounding Central Texas communities.